Didn't work for me. Showed graphs but didb"t print anything.
Just will not work for me! Every other one of Wolphi's ham radio apps work very well and I love them. But this one just won't decode any morse I have tried it with at any speed. Yet other morse apps, even free ones work fine. It will not work on my Sony Xperia phone or on my no-name tablet. David vk2dmh.
Works well for longer transmissions I tuned my SW radio to W1AW and was reading along in 15 seconds. That isn't a common situation, though. I tried it on a few other QSOs next. There was enough drift that I had to keep chasing the waterfall around, and the calls were short so it never really locked on. Still, it distinguished between two different senders even though they were going simultaneously. I would have a hard time doing that myself. If my VFO was more stable, I think it would've worked very well.
Not bad. Does work but hopping for something better! Waterfall is to small to properly setup frequency. Maybe making it bigger or perhaps be able to change horizontal axis frequency range would be better. Also even all my apps have quite high input Mic gain, this app gain is quite low. Care to debug? 73 de SV1CDN.
Works great for me. I'm using this app with my fully restored Drake R8 receiver. I have my receiver hooked up to a good external speaker, and if I want to find out what the CW says I just put my phone in front of speaker, set the slider and starts right up. Very easy to use, works as good as the MFJ reader. Well worth it for me.
Good but could be easier I found moving the red lines to isolate the desired freq awkward. Needs + and - buttons to make it easier. Had to turn squelch off to get decoding working, once done and freq finally right worked well. Verdict, fiddly without improved user interface, but love it de G4POI
The first and only app allowing WSPR transmission using your Android device!