Node Remote for Allstar Nodes

Matthew P Miller

About this app

Node Remote is compatible with ALLSTAR nodes.

PLEASE READ: Configuration guide here: http://www.m0dqw.com/node-remote-guide/

Features:

* Send pre-defined config commands to the Node
* Visibly see when your Node is transmitting or receiving
* Direct dial a node (if node number is known)

App prerequisites:

1) You must know your Node local IP address
2) Your device must be on the same local area network as your Node
3) App uses username/password from manager.conf
4) bindaddr in manager.conf file must be set to 0.0.0.0 or your device local IP must be added
5) Default manager port is 5038, but can be changed in app if you have changed it

Please report all bugs or features requests by email to: [e-mail]

This app is NOT directly affiliated with ALLSTARLINK.

Installation document can be read here: http://www.m0dqw.com/wp-content/uploads/2018/04/NodeRemoteGuide.pdf

Ratings and reviews

Overall a very good app for what it was designed to do. What would make this app better Is the ability to have a drop down with stored IP addresses for multiple nodes. I have three nodes with some on different networks so each time I have to fumble the IP address in. Another thing that would be neat would be a scan local network option for the node. Either way, I wouldn't have to fat finger IP addresses in all the time. Thanks for the hard work.

Works well, but needs to be able to store any number of node memories, not just 11. It also needs to be able to store the full DTMF strings in those memories, and not hard code a disconnect plus *3 before each one. It's a shame that suggestions are ignored and that development seems stalled.

Author NEVER responds to emails. Doesn't seem to care if you have problems, just takes your money. Tried to use this app with my Hamvoip repeater and it kicks my nodes offline and locks the repeater. Junk software...

What’s new

Added Android 13 support