E+ Service

ENERGYPLUS TEKNOLOJİ AŞ

About this app

E+ Service (EnergyPlus Service) is the official commissioning app for EnergyPlus gateway boards. It is the only interface that works while the board has no IP address yet: your phone connects directly to the board over Bluetooth Low Energy (BLE), you configure the network, the board comes online and you continue in the browser-based web interface.

■ SUPPORTED DEVICES
• EPL-MBAC-200W — WiFi / Modbus / BACnet gateway
• EPL-GSM-100 — Ethernet / Modbus RTU / SMS gateway
The app recognises the model of the board it connects to and shows only the screens that apply to it; there is no model to pick.

■ WHAT YOU CAN DO
• WiFi: let the board scan nearby networks, pick one, enter the password; DHCP or static IP
• Ethernet: DHCP or static IP, gateway, mask, DNS
• Fieldbus (RS-485): Modbus RTU or BACnet MS/TP, baud rate, parity, stop bits, timeout
• BACnet router (MS/TP ↔ IP) and network numbers — set during commissioning, before the board is on the network
• Modbus TCP server port (EPL-GSM-100)
• Cellular: APN presets, user, SIM PIN (EPL-MBAC-200W)
• GSM: SIM and network status, signal strength, up to 10 phone numbers allowed to send SMS commands (EPL-GSM-100)
• Status screen: firmware version, serial number, IP addresses, link state

■ SAFE COMMISSIONING
• Settings are first written to the board's memory and only become permanent when you tap "Save" — a half-finished setup never breaks the board.
• While there are unsaved changes the app keeps reminding you and asks before you leave.
• The link is encrypted (LE Secure Connections) and nothing can be read or changed without the board's password.
• Invalid settings are flagged on screen before they are sent (invalid IP, equal router network numbers, bad phone numbers, etc.).

■ TRY IT WITHOUT A BOARD — DEMO MODE
Tap the flask icon on the scan screen. Two simulated boards (one of each model) appear and you can explore every screen without real hardware. In demo mode no setting is sent to any real device.

■ PRIVACY
The app has no internet permission. No account, no ads, no analytics, no tracking. Settings travel only between your phone and the board you connect to over Bluetooth.

■ REQUIREMENTS
• Android 7.0 or later phone with Bluetooth Low Energy
• An EnergyPlus gateway board for real commissioning (not needed for demo mode)
• "Nearby devices" permission on Android 12+; on Android 11 and earlier the operating system requires location permission for BLE scanning — the app does not use your location.

Turkish and English interface. Support: [e-mail]

What’s new

First release. Try every screen without a board in demo mode: tap the flask icon on the scan screen.