Quicktag

Krobox Sdn Bhd

About this app

QuickTag lets you set up and fine-tune ELR NFC-enabled LED drivers straight from your phone - no gateway, no wiring to the DALI bus, and no PC software. Just hold your phone near the driver and configure it in seconds.

Designed for electricians, lighting installers, and commissioning engineers, QuickTag makes on-site driver setup fast, repeatable, and reliable.

WHAT YOU CAN DO
- Read a driver instantly: model, firmware version, and current settings with a single tap.
- Set DALI parameters: power-on level, min/max dim levels, fade time, fade rate, dimming curve (log or linear), and system-failure level.
- Tunable white (DT8): configure power-on colour, warmest/coolest colour limits, and view the physical CCT range.
- Current cap: limit the driver's output current to match your luminaire.
- flexiK: lock a tunable-white driver to a single fixed colour temperature.
- Scenes and groups: assign DALI scenes and group membership.
- Short address: set the DALI short address.
- Copy and paste: copy a fully configured driver and replicate its settings onto other drivers in one tap.
- Driver status: check diagnostics and operating information.

HOW IT WORKS
QuickTag talks to your driver over NFC (ISO 15693). Every change is written to the driver's memory with read-back verification, so a brief slip won't corrupt the tag, and your settings survive power cycles.

REQUIREMENTS
- An Android phone with NFC.
- A compatible ELR NFC-enabled LED driver.

Hold your phone flat against the driver's NFC target, keep it steady while reading or writing, and you're done.

What’s new

Update SDK version