The app fails to connect to the device during the pairing process. No debug information available except for step 3: "Paring is in progress. The device is connected to the smartphone. Please wait a few seconds.". This keeps going on for >10 minutes when I give up. I'll adjust my rating when the bugs are fixed of course. I just checked with gatttool on the command line and I can send messages, so it's really just about bugs in your app, the device and the connection works fine
Smart Room Control Enables me to set heating to come on in rooms that aren't used all the time, the front lounge only used at weekends, easy to override if using other times. Sometimes need to tap boost a couple of times to get Bluetooth to connect.
It works, mostly, kinda. Pairing is annoying (there is a screen without any action buttons or explanation), and programming is less featured than using the on-device buttons, i.e. you cannot choose to heat until 24:00 or 23:59. But at least it's not styled in some fancy unusable way.
Not bad. This worked fine on my Android 5.1.1 tablet. Note that it will not pair successfully until the valve has been fitted and calibrated on the radiator. I used the EQ3 units to replace danfoss TRV4s which were a straight swap - very easy. Note that these are not a modulating valve like a normal TRV, they are either on or off so your heating system can easily become inbalanced. You will need to adjust the other valve on each rad to limit the flow of water. A few improvements needed: 1) The naming of rooms is just weird. Once you have named all your valves navigating between them is a pain. 2) It would be REALLY great to see the measured temperature in each zone. Very hard to set without it.
Yes it does work but it limits the functionality of the valves. The concept of having a baseline temperature is not how the valves work when setting up manually. I don't want the same base temperature during the night as during the day. App is not very intuitive and needs a lot of trial and error to set up. The valves themselves are great but this app lets them down very badly.
Doesn't work for Android, will not pair spent the best part of an hour trying on multiple Android devices without any joy. But worked first time for my work iPhone
* Problems with the connection have been resolved.
For this purpose, proceed as follows :
Open calor BT -> Open a room -> menu (top left corner) and select a device. Select "Update Firmware" to transfer the new device firmware. (If necessary, perform a reset on the device first to avoid connection problems)
* Problems with retrieving the week program fixed.
* Manual mode was abandoned under certain conditions .
Scan and discover your Bluetooth low energy devices with nRF Connect for Mobile.
Cooling & lower CPU temperature, tracking device and close the application run.
App to cool down the phone temperature, CPU cooler and WiFi booster