Controller test and gamepad tester for a real controller connected by USB cable (OTG) or Bluetooth: measure stick drift on a map, check every button and trigger, and share a dated report of the results.
▶ STICK DRIFT, MEASURED AND DRAWN
• Three short steps per stick: hands off for 5 seconds, push to each edge and let it snap back, then roll it slowly around the edge about 3 times.
• One map shows the resting samples, where the stick stopped after you let go, its farthest reach in 72 sectors of 5° and your dead-zone ring.
• Center offset, jitter (95 %), return error and a drift score, with its rule: below 0.05 Good, 0.05–0.15 Check, from 0.15 Drift suspected.
• Roundness error and the min–max reach of the edge, once at least 64 of the 72 sectors are covered.
• Set your game's dead zone (0 to 0.30) and the app tells you when the drift is outside it.
▶ A DATED REPORT TO SHARE
• One card with the date, phone model, controller name, vendor and product numbers, both stick maps and the result of every check.
• Share it as an image (1080 × 1350), as a PDF or as plain text — for selling or buying a used controller, or before and after a repair.
• Save it to history: the 50 newest reports stay on this phone, and the stick drift of a new report is compared with the previous report of the same controller (better, worse, about the same).
• Checks you did not run are listed as "Not checked", never as passed.
▶ LIVE INPUT
• Buttons light up on a neutral controller drawing, labelled by position, by letter or by key name. Other buttons appear as extra buttons.
• Both sticks live with raw values to 4 decimals and a short trail, plus L2 and R2 bars.
• Several controllers at once, each with its own results, and two controllers side by side.
▶ MORE CHECKS
• Buttons: every listed button pressed once, one press read as several, and buttons reported as held down. D-pad from keys or hat axes.
• Triggers from 3 slow pulls: rest, full pull, digital or analog with about how many bits.
• Axis wizard when sticks or triggers are mixed up; the result is saved for that controller.
• Vibration: motor 1, motor 2 or both, and a pattern of up to 6 steps; light, medium, strong and a ramp when the controller has strength levels.
• Polling rate in Hz with jitter, and the in-phone part of the input delay (p50 and p95).
• Battery, motion sensors, light color and touchpad, when the controller reports them.
• Raw log of the last 200 events, exported as a CSV file.
• Help for USB and Bluetooth pairing, a "not detected" checklist and a shortcut to Bluetooth settings.
▶ GOOD TO KNOW
• Test results, not a repair: the app does not calibrate sticks, remap buttons or change the controller's firmware.
• It tests a physical controller. It does not put a gamepad on the screen and does not play games.
• Values are what this phone received on this connection. If the controller's own firmware applies a dead zone, small drift can read as 0.
• The input delay covers only the part inside the phone; the controller's own scanning, the wireless link and the screen add more.
• Event times have 1 ms steps, so fast controllers show "500 Hz or more". Trigger resolution from 3 pulls can read lower than the real one.
• Battery level, separate motors, light and motion sensors need system version 12 or newer, and only appear when the controller reports them.
• Reports, history and controller profiles stay on this phone, with no sign-in. A report goes only where you share it.
Gamepad tester: stick drift map, buttons, triggers, rumble and a dated report