Reprap Control

DEVMEL

Mayelana nalolu hlelo lokusebenza

Lolu hlelo lokusebenza umthumi G-code isikhombimsebenzisi sokuqhafaza ngesandla ukulawula reprap 3D iphrinta umshini wakho.

Izici:
 - Homing futhi Moving X, Y futhi Z Axis
 - Moving the extruder (phambili / emuva intambo)
 - Setting umlomo wombhobho nombhede lokushisa
 - Qala ifayela / ikhefu kusuka ekhadini le-SD
 - Ifayela Current zokunyathelisa isimo
 - Lokuphotha noma laser On / Off


Oluvumelana:

 - Bluetooth
    * Module HC-05, HC-06
    * Noma-adaptha Bluetooth-Serial (00001101-0000-1000-8000-00805f9b34fb UUID)
 
 - USB ne-adaptha OTG USB Bridge chips
    * Silicon Laboratories CP210X,
    * FTDI FT232
    * Okhiqizayo PL2303
    * Arduino
    * CDC / ACM

 - LinkBus (Ethernet kudivayisi UART)
    * Bheka http://devmel.com/linkbus


izilungiselelo Ukuxhumana:
 - Translations into Zulu Rate: 1200 ~ 250000
 - Data Bits: 5, 6, 7 noma-8
 - Stop Bits 1 noma 2
 - Silinganiso Bit: none, ngisho noma okuthile


amanothi:
 - Marlin firmware uyayalwa
 - Akukho isikhangiso
 - USB Host ukwesekwa kungaba isebenze (kumadivayisi ahanjiswe kuphela)
 - Open Source https://github.com/devmel/ReprapControl-Android